Rocscience RocSlope 1.0 x64

Descriptions

RocSlope, 3D Block Stability Risk Assessment for Rock Slopes. For 3D slope geometries of benches, cuts, and entire open pits, model structurally controlled failure in rock slopes exhibiting jointing (faults, joints, bedding, folds, foliations). Define joints as any combination of measured joints, synthetically sampled joint sets, or discrete surfaces, defined by orientation and location. Determine all valid blocks which could be formed by the intersection of joints. Once blocks are computed, determine each block’s stability using the limit equilibrium method to obtain a factor of safety, taking into considering weight, shear strength, water pressure, loading and supports. Predict the locations and magnitudes of failures over the extent of the slope by creating heat maps to show locations with the lowest factors of safety, largest failure volumes and depths, and greatest support requirements. Perform probabilistic analysis to model the variability in rock unit weight, joint shear strength, and water pressure parameters and obtain location-specific probabilities of failure. Generate statistical plots like histograms, cumulative and scatter plots for any selection of blocks, and fit distributions and regression lines through the data. Perform probabilistic analysis to model the variability in rock unit weight, joint shear strength, and water pressure parameters and obtain location-specific probabilities of failure. Generate statistical plots like histograms, cumulative and scatter plots for any selection of blocks, and fit distributions and regression lines through the data.

Features of Rocscience RocSlope :

• Model 3D Geological Structures
• Block Stability Analysis
• Probabilistic Analysis
• Assess and locate large and small-scale failures across the benches of an open pit as part of optimal pit design, safety planning and risk mitigation during the design and operational stages.
• Geological hazard assessment of the stability of rock slopes adjacent to or overlying civil infrastructure such as roads, highways, railways, and bridges. Apply slope stabilization measures by modeling the effects of rock reinforcements and drainage.

System Requirements

Operating System

Windows 10 (64-bit), Windows 11 (64-bit)

RAM

Minimum requirement : 32 GB
Recommended for terrain meshes > 100,000 triangles: 64 GB

Hard Disk

Picture

Buy

For any question Contact us

Size

440 MB